Every 3000 Hours; Checking Injection Pump; Every 1 Year; Checking Fuel Lines - Kubota ZD1011-AU Operator's Manual

EVERY 3000 HOURS

BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.

EVERY 1 YEAR

BChecking Fuel Lines
If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
(See "Checking Fuel Filter" in "EVERY 100 HOURS" in
"MAINTENANCE" section.)
BChecking Radiator Hose and Clamp
If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
To avoid serious injury or death:
A Be sure to stop the engine and remove the key
before checking radiator hose and clamps.
1. If hose clamps are loose or water leaks, tighten clamps
securely.
2. Replace hoses and tighten hose clamps securely. If
radiator hoses are swollen, hardened or cracked, then
replace them immediately.
(1) Radiator core
(2) Radiator hose
BChecking Hydraulic Hose
If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
To avoid serious injury or death:
A Be sure to stop the engine and remove the key
before checking and replacing the hydraulic
hose.
A Allow the transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
A Escaping hydraulic fluid under pressure has
sufficient force to penetrate the skin causing
serious personal injury. Before disconnecting
lines, be sure to relieve all pressure. Before
applying pressure to the system, make sure all
connections are tight and that lines, pipes, and
hoses are not damaged.
1. Check to see that all lines and hose clamps are tight
and not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
(1) Mower lift cylinder hose
MAINTENANCE 67