Table of Contents
Advertisement
System Utilities
Introduction
Most systems are already configured by the manufacturer or the dealer. There is no need to run
Setup when starting the computer unless you get a Run Setup message.
The Setup program loads configuration values into the battery-backed nonvolatile memory called
CMOS RAM. This memory area is not part of the system RAM.
If you repeatedly receive Run Setup messages, the battery may be bad. In this case, the
NOTE:
system cannot retain configuration values in CMOS. Ask a qualified technician for assistance.
Before you run Setup, make sure that you have saved all open files. The system reboots
immediately after you exit Setup.
Chapter 2
Chapter 2
22
Advertisement
Table of Contents
