System Utilities
BIOS Setup Utility
This utility is a hardware configuration program built into a computer's BIOS (Basic
Input/Output System).
The utility is pre-configured and optimized so most users do not need to run it. If configuration
problems occur, the setup utility may need to be run. Refer to Chapter 4, Troubleshooting
when a problem arises.
To activate the utility, press
of screen.
The default parameter of F12 Boot Menu is set to Disabled. To change the boot device
without entering BIOS Setup Utility, set the parameter to Enabled.
To change the boot device without entering the BIOS SETUP, press F12 during POST to enter
the multi-boot menu.
Navigating the BIOS Utility
Six menu options are:
Main
Advanced
Power
Security
Boot Options
Exit
To navigate through the following:
Screen - use the left and right arrow keys
Item - use the up and down arrow keys
Select - press Enter
Change options - press + or -
Load User-defined defaults - press F7
Save as User-defined - press F8
Optimized Defaults - press F9 (When access level is Administrator)
Save & Exit - press F10
Exit - Press / Esc
NOTE:
NOTE:
Parameter values can be changed if enclosed in square brackets [ ]. Read parameter
help carefully when making changes to parameter values. Parameter help is found in
the Item Specific Help area of the screen.
NOTE:
NOTE:
System information is subject to specific models.
System Utilities
during POST (power-on self-test) when prompted at the bottom
F2
0
0
2-3