Figure 1-7: Installing The Instrument In The Rack Slides - Tektronix B020000 User Manual

Getting Started
Installing the Instrument
Figure 1–7: Installing the instrument in the rack slides
Rack Adjustments
Rack Slide Maintenance
Removing the Instrument
1–8
Install the instrument in the rack, as shown in Figure 1–7.
TO INSTALL:
1. Pull the slide-out track section to the fully extended position.
2. Insert the instrument chassis sections into the slide-out
sections.
3. Press the stop latches and push the instrument toward the
rack until the latches snap into their holes.
4. Again press the stop latches and push the instrument fully into
the rack.
5. Tighten the front-panel retaining screw.
TO REMOVE:
1. Loosen retaining screw and pull instrument outward until the
stop latches snap into the holes.
2. Press stop latches and remove instrument.
After installation, the slide tracks may bind if improperly adjusted. To adjust the
tracks, slide the instrument out about 10 inches, slightly loosen the screws
holding the tracks to the front rails, and allow the tracks to seek an unbound
position. Re-tighten the screws and check the tracks for smooth operation by
sliding the instrument in and out of the rack several times.
Once the instrument is in place within the rack, tighten the knurled retaining
screw to fasten it securely into the rack.
The slide-out tracks do not require lubrication. The dark gray finish on the tracks
is a permanent, lubricated coating.
First, loosen the front-panel knurled retaining screw. Grasp the front handles and
pull the instrument out until all three slide sections latch. This holds the
instrument firmly in position.
To completely remove the instrument, first, be sure to disconnect all cabling.
Then, press both release-latch buttons (visible in the stop-latch holes) and
carefully slide the instrument free from the tracks.
SPG422 Component Digital Sync Generator User Manual