All specifications are nominal and may change as design improvements occur. Greenlee Tools, Inc. shall not be liable for munications. Operation of this equipment in a residential damages resulting from misapplication or misuse of its products.
EK6ATLX and EK6ATILX Battery-powered Crimping Tool IMPORTANT SAFETY INFORMATION SAFETY Wear eye protection when operating ALERT or servicing this tool. SYMBOL Failure to wear eye protection could result in serious eye injury from flying debris or hydraulic oil. This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage.
Page 4
EK6ATLX and EK6ATILX Battery-powered Crimping Tool IMPORTANT SAFETY INFORMATION Do not dispose of batteries in a fire. They will vent Do not allow anything to contact the battery fumes and may explode. terminals. Failure to observe this warning could result in severe •...
EK6ATLX and EK6ATILX Battery-powered Crimping Tool Operation • Inspect tool and dies before use. Replace any • Do not use this tool for continuous use. After 30 to worn or damaged parts. A damaged or improp- 40 cycles, allow the tool to cool for 15 minutes.
Page 7
EK6ATLX and EK6ATILX Battery-powered Crimping Tool Operation (cont’d) Pressure Sensor Crimping Procedure This tool is equipped with a pressure sensor that alerts 1. Insert cable fully into connector. Center the connec- the user of an incomplete crimp. tor between the nibs.
EK6ATLX and EK6ATILX Battery-powered Crimping Tool Connector Selection Tool Range: Copper — 4 AWG to 500 kcmil (except as noted ∆ This tool is cUL and UL classified for use with the following connector brands: CONNECTOR BARREL PENN- NO. OF...
3. Inspect the rotation of the head assembly. Fully debris or hydraulic oil. retract the ram. The head should rotate no more than 360°. If damage is detected, contact Greenlee customer service at 800-435-0786 for warranty service or repair. After use: 1.
EK6ATLX and EK6ATILX Battery-powered Crimping Tool Troubleshooting Before You Begin 2. Use a nonflammable contact cleaner or pencil eraser to clean the electrical contacts on the battery 1. Make sure that the battery is charged. Recheck the battery after several minutes to make sure the and tool.
Page 11
EK6ATLX and EK6ATILX Battery-powered Crimping Tool Greenlee Tools, Inc. 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
Need help?
Do you have a question about the EK6ATLX and is the answer not in the manual?
Questions and answers