AIMS Power PWRNV1250W Instruction Manual

AIMS Power PWRNV1250W Instruction Manual

Dc to ac power inverter

Advertisement

Quick Links

DC TO AC POWER INVERTER
PWRNV1250W
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PWRNV1250W and is the answer not in the manual?

Questions and answers

Summary of Contents for AIMS Power PWRNV1250W

  • Page 1 DC TO AC POWER INVERTER PWRNV1250W INSTRUCTION MANUAL...
  • Page 2: Basic Operation

    • When unpacking, make sure that the inverter is in good condition. If any parts are missing or broken, please call AIMS Power, Inc. at the number found on the warranty card. • Place the power inverter on a flat surface. Make sure it has adequate ventilation and is not in direct sunlight.
  • Page 3 operation of the inverter. It also reduces the fear of being stranded with a dead battery (dependent on health of battery). • This device should only be serviced by a qualified technician. This item does not have any serviceable parts. •...
  • Page 4: Battery Use

    Battery Use • To avoid over-discharging your vehicle battery, we recommend running your engine for 10-20 minutes to recharge the vehicle's battery if battery voltage drops <11V. • To properly size your battery, use the following formula: Volts * Amps = Watts or Watts/Volts = Amps.
  • Page 5: Remote On/Off Switch

    current is in the yellow zone. Operation in the red zone of the display will result in protective inverter shutdown. NOTE: The bar display will only monitor DC current and voltage not AC. If you need to measure AC output you will need to use a TRUE RMS MULTI METER.
  • Page 6: Troubleshooting

    • Allow at least one inch of clearance around the Inverter for air flow. Ensure the ventilation openings on the rear and bottom of the unit are not obstructed. • Do not connect the inverter directly to another AC power source. Damage may result, and such damage will void the inverter warranty.
  • Page 7: Maintenance

    MAINTENANCE Very little maintenance is required to keep your inverter operating properly. You should disconnect input power first and then clean the exterior of the unit periodically with a dry cloth to prevent accumulation of dust and dirt. At the same time, tighten the screws on the DC input terminals.
  • Page 8: Warranty

    In no event shall AIMS be liable for indirect, special or consequential damages. This warranty only applies to AIMS Power branded products. All other name brand products are warranted by and according to their respective manufacturer. Please do not attempt to return non-AIMS Power branded products to AIMS Power.

Table of Contents