Table of Contents
Advertisement
5. Press Enter . Computer sets Supervisor Password parameter to Set.
NOTE:
NOTE:
Users can choose to enable the Password on Boot parameter.
6. Press F10 to save changes and exit from the BIOS Setup Utility .
Boot
Use this tab to set the preferred drive sequence in which the Setup Utility attempts to boot the
operating system. By default, the computer searches for boot devices in the following order:
1. Hard disk drive
2. Optical disc drive
3. Network boot
4. External USB hard drive
5. External USB optical drive
6. External USB bootable device
Press
to select a device and press F5 or F6 to move it up or down the list.
Figure 2-8. BIOS Boot
2-10
0
System Utilities
Advertisement
Table of Contents
