Startup Configuration - Acer TravelMate 210 Service Manual

Startup Configuration

The Startup Configuration screen contains parameter values that define how your computer behaves on
system startup.
Boot Display -------------------------------------
Screen Expansion -----------------------------
Hotkey Beep ------------------------------------
Fast Boot -----------------------------------------
CPU Power Management Mode
Boot Drive Sequence:
1st. --------------------------------------------
2nd. -------------------------------------------
3rd. --------------------------------------------
= Move highlight bar,
The following table describes the parameters in this screen. Settings in boldface are the default and
suggested parameter settings.
Parameter
Boot Display
Screen Expansion
Hotkey Beep
Fast Boot
CPU Power Management Mode
Boot Drive Sequence
32
Startup Configuration
----------
= Change setting, F1 = Help
Description
Sets the display device on boot-up.
When set to Auto, the computer automatically
determines the display device when the computer
starts up. If an external display device (e.g., monitor)
is connected, it becomes the boot display; otherwise,
the computer's display screen is the boot display.
When set to Both, the computer outputs to both the
computer display screen and an external display
device if one is connected.
When set to enabled, the screen will automatically
adjust the display to fit the screen when the resolution
is set to 640 x 480.
When enabled, the computer gives off a beep when a
hotkey (key combination is pressed).
Allows you to define your system's booting process;
whether to skip some POST routines or proceed with
the normal booting process.
Specifies the order in which the computer starts up
from. See the section below.
[Both]
[Enabled]
[Enabled ]
[Enabled ]
[ Auto ]
[Floppy Disk]
[CD-ROM]
[Hard Disk]
Both or Auto
Enabled or Disabled
Enabled or Disabled
Enabled or Disabled
Auto or Disabled
1st: Floppy Disk,
2nd: CD-ROM,
3rd: Hard Disk
Page 1/1
Options
Chapter 2