Startup Configuration - Acer Extensa 500 Service Manual

Startup Configuration

The Startup Configuration screen contains parameters that are related to
computer startup.
The following table describes the parameters in this screen. Settings in
boldface are the default and suggested parameter settings.
Parameter
Boot Display
Memory Test
Silent Boot
System Boot
Drive
Chapter 2
Description
Sets the display on boot-up.
When set to Auto, the computer automatically
determines the display device. If an external
display device (e.g., monitor) is connected, it
becomes the boot display; otherwise, the computer
LCD is the boot display. When set to Both, the
computer outputs to both the computer LCD and an
external display device if one is connected.
Options: Auto or Both
Enables or disabled memory test on boot-up.
Options: Disabled or Enabled
When enabled, hides the computer startup
messages on boot-up (the Extensa logo displays)
Options: Enabled or Disabled
Specifies the boot sequence (the order of drives
that the computer will attempt to boot from). For
example, when set to Drive A Then C, the computer
attempts to boot from the floppy drive. If no
bootable floppy disk is in drive A, the computer
boots from the hard disk.
Options: Drive A Then C, Drive A, Drive C, Drive C
Then A
35