Table of Contents
Advertisement
5.
Detach the earth wire screw, terminal wire (Brown), terminal wire (Black),
terminal wire (Red) and earth wire screw (Green).
16.1.3
To remove discharge grille
16.1.4
To remove control board
9.
Pull out the
electronic
controller halfway.
8.
Remove screw to
remove terminal
board complete.
7.
Detach the
connectors
CN2 (Black),
GND (Green),
and CN1 (White)
then remove the
high voltage
generator.
6.
Remove the
indicator complete
then detach the
connectors CN-DISP
and CN-RCV.
Figure 3
13. Then pull the discharge grille downward gently to dismantle it.
10. Detach 8 connectors as labeled from the electronic controller.
Then pull out electronic controller gently.
12. Pull out to remove the drain
hose from the discharge grille.
11. Detach the bottom plate then remove
2 screws of the discharge grille.
Figure 5
14. Remove the 4 screws holding
the control board then pull out
the control board.
Figure 6
83
Figure 4
AC303
CN-FM
CN-TH
CN-STM2
CN-STM1
CN-MSENS
CN-STM3
CN-STM4
Advertisement
Table of Contents
