Driveline Shield Chains; Precision Clevis - C000-360 - Schulte FX-520 Operator's Manual

Driveline Shield Chains

Attach CV shield chain to tractor or cutter hitch
allowing sufficient slack for turning.
IMPORTANT: OSHA, ASABE and SAE standards
require that all rotating shafts be guarded against
contact. The unchained plastic shields can rotate
with the driveline, but must stop when they contact
another object.
Note: Driveline shields may also be chained to the
gearbox cone using the supplied chains.
The shields must be regularly greased and
checked that they rotate freely on the driveline.
Refer to the Lubrication Section for greasing
intervals.

Precision Clevis - C000-360

Adjust the opening of the precision clevis by
shimming the wear plate with the spacers. Remove
the two 5/8" bolts and lockwashers and stack the
spacers between the wear plate and the hitch block
until the opening measures less than 1/8" taller than
the drawbar. Replace unused spacers under the
hitch block and reinstall the lockwashers and bolts.
NEVER USE YOUR HANDS TO STEADY THE HITCH BLOCK WHILE THE TRACTOR IS
BEING BACKED INTO THE HITCH.
NEVER STAND BETWEEN THE TRACTOR AND THE ROTARY CUTTER WHILE THE
TRACTOR IS BEING BACKED INTO THE HITCH.
FX-520 06/16
© 2016 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-5