Table of Contents
Advertisement
Page 8
Auto Bypass Re-entry Zones (New Program Only) (Not evaluated by UL)
EntAU B
•
Enter the zone numbers of zones to be Auto Bypass Re-entry zones.
•
Valid entries are from 01 to 64. Directly enter each zone number, including leading zeros.
Zn#XX
•
Press
•
(Direct Entry)
Auto Bypass Re-entry Zones allow the system to be armed with the zone faulted but come back into the
system (armed) when the zone is subsequently secured.
Enable No EOLR Zones (New Program Only)
EnNEO L
•
Press the NEXT/YES button to program all zones except 24 Hr & fire zones for No End Of Line Resis-
tor. Press the PRIOR/NO button to continue. NOTE: Do not program this feature for UL Installations.
Y/N
(Press YES or NO)
Enable Telco Line Fault Test? (New Program Only)
Telco
•
•
Ln Fi t
NOTE: If enabled, a Telco Line Fault Test Delay of 60 seconds will automatically be programmed.
Y/N
(Press YES or NO)
Enable Burg Output Chirp on KeyFob? (New Program Only)
KF Ou t
•
•
Chirp
NOTE: The Burg Output will chirp once on Keyfob Arm and twice on Keyfob Disarm.
Y/N
(Press YES or NO)
Enable SIA CP01? (New Program Only)
Enabl e
•
•
CP01?
The SIA CP-01 Features are designed to reduce the incidence of false alarms. See WI1424, "Installer Pro-
gramming Quick Reference Chart SIA False Alarm Reduction" and "GEM-P1664 Factory Default Description"
for more information. NOTE: Do not enable unless reporting, otherwise system trouble Fail to Communi-
Y/N
cate may occur.
(Press YES or NO)
Number of Keypads in Area 1
Ent A 1
Directly enter the total number of Keypads to be installed in Area 1. Valid entries are from 01 to 07. Directly
enter the number of keypads, including leading zeros. Use number buttons
#KP 0 1
Press
keypads can only be assigned in Direct Address Programming. See Keypad Options.
(Direct Entry)
Central Station Receiver 1 Telephone Number
Phone #
Using number buttons, enter telephone number of up to 16 digits including prefix letters, if necessary, for
receiver 1. Use number buttons
_ _ _ _ _ _
and
Detection = "E". Pressing
_ _ _ _ _ _
ton to proceed.
NOTE:
(Direct Entry)
Programming. See CS Receiver Options.
X
GEM-P1664 Programming Instructions
U
to save and then repeat for any additional zone(s), press the NEXT/YES button to proceed.
Press the NEXT/YES button to enable Telco Line Fault Test.
Press the PRIOR/NO button to continue.
Press the NEXT/YES button to enable Burg Output Chirp on KeyFob Arm / Disarm.
Press the PRIOR/NO button to continue.
Press the NEXT/YES button to enable.
Press the PRIOR/NO button to continue.
U
for a zero. Press
0
1
through
G 1
G 5
0
Central Station Receiver 2 and 3 Telephone Numbers can only be entered in Direct Address
to save. Press the NEXT/YES button to proceed. NOTE: Area 2, 3 or 4
through
for digits 1–9; press the
9
for letters B–F, respectively. NOTE: Pre-Dial Delay = "D"; Dial-Tone
will produce a blank space (•). Press
WI1423A 1/06
through
1
9
buttons for a zero
G 0
U
to save. Press the NEXT/YES but-
L
NAPCO Security Systems
. NOTE:
Advertisement
Table of Contents
