Table of Contents
Advertisement
WI1423A 1/06
ZONE DESCRIPTIONS: GEM-K3DGTL cannot be used to enter Zone Descriptions. To enter Zone Descriptions, you must use the GEM-K1CA
Keypad or the Napco Quickloader Software.
DATE ENTRY: GEM-K3DGTL cannot be used to enter the date. To enter Date, you must use the GEM-K1CA Keypad (Version 5 or later) or the
Napco Quickloader Software.
TIME ENTRY: GEM-K3DGTL cannot be used to enter the time. To enter Time, you must use the GEM-K1CA Keypad (Version 5 or later) or the
Napco Quickloader Software.
33
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
rE
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
(Direct Entry)
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press
Program Mode for further programming or press
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode, press
to enter the Address Program Mode; (b) access Location 2285 (Clear Program) or 2286 (Cold Start); (c) press
C
(d) press
to exit the Dealer Program Mode. A System Trouble Condition will occur. Press
C
L
NAPCO Security Systems
Dealer Code
Directly enter the Dealer Code, including leading zeros. Use the
NOTE: Press
for a zero. Press
0
Re-enter the Dealer Code to verify the previous code. Press
button to proceed. NOTE: The Dealer Code can be two or more digits (up to 6 digits).
once again to end all programming and resume normal keypad operation.
C
1
U
to save.
U
to save. Press the NEXT/YES
to enter the Direct Address
C
C
X
GEM-P1664 Programming Instructions
Page 19
through
buttons.
9
U
and then
to silence the keypad.
Advertisement
Table of Contents
