Setting The Incoming Port; Setting The Frequency Of Page Refreshes - 3Ware 9550SX-4LP User Manual

Setting the Incoming Port #

You can set the port which 3DM uses to listen for incoming messages. If you
are not sure which port would be the best to use, leave this set to the default
port of 888.
To set the incoming port
1 Click
2 In the
number in the
3 Click
The page refreshes, and a message at the top of the screen confirms that
the listening port has been changed.

Setting the Frequency of Page Refreshes

Since the status of the drives attached to your 3ware RAID controller can
change while you are viewing information about them in 3DM, it is important
to refresh the page information regularly. That way you can be assured that
the information you see in 3DM is current.
You can manually refresh the information on a page by clicking
Page in the menu bar. But you can also have 3DM refresh the information on
a regular basis.
To set the frequency of page refreshes
1 Click
2 In the
you want the page to be refreshed in the
www.3ware.com
on the menu bar.
3DM 2 Settings
section of the 3DM 2 Settings Page, enter the port
Incoming Port #
Listening Port
Change Port .
on the menu bar.
3DM 2 Settings
section of the 3DM 2 Settings Page, select how often
Page Refresh
Note: If you do not want 3DM to refresh the screen automatically,
select in the
Never Minutes Between Refresh
refresh manually by clicking Refresh on your web browser.
Setting Up 3DM Preferences
field.
Minutes Between Refresh
Refresh
field.
field. You can then
83