Outside Mirrors - Subaru 2006 Forester Owner's Manual

3-28
Instruments and controls
Compass zone adjustment
3
4
5
8
7
6
Compass calibration zones
1. The zone setting is factory preset to
Zone 8. Refer to the "Compass calibration
zone" map shown above or one attached
to the end of this manual to verify that the
compass zone setting is correct for your
geographical location.
2. Press and hold the right button for 3
seconds then release, and the word
"ZONE" will briefly appear and then the
zone number will be displayed.
3. Press the right-hand button repeatedly
to cycle the display through all possible
zone settings. Stop cycling when the cor-
rect zone setting for your location is dis-
played.
4. Releasing the button for 3 seconds will
exit the zone setting mode.

Outside mirrors

13
12
11
10
9
300580
Convex mirror (passenger side)
Objects look smaller in a convex
mirror and farther away than when
viewed in a flat mirror. Do not use
the convex mirror to judge the dis-
tance of vehicles behind you when
changing lanes. Use the inside mir-
ror (or glance backwards) to deter-
mine the actual size and distance of
objects that you view in convex mir-
ror.
Remote control mirror switch
1
1) Selection switch
300146
2) Direction control switch
The remote control mirrors operate only
when the ignition switch is in the "ON" or
"ACC" position.
1. Press either end of the selection
switch, "L" for the left, "R" for the right.
2. Move the direction control switch in the
direction you want to move the mirror.
3. Return the selection switch to the neu-
tral position to prevent unintentional oper-
ation.
The mirrors can also be adjusted manual-
ly.
2
300581