Subaru 2006 Forester Owner's Manual page 101

2-10
Keys and doors
Programming transmitter codes into
system:
Bag containing transmitter
Transmitter circuit board
To register a new transmitter with the key-
less entry system, it is necessary to pro-
gram the transmitter's code (identification
number) into the system. A label showing
the code is affixed to the bag containing
the transmitter, and another is affixed to
the circuit board inside the transmitter. If
there is no bag, open the transmitter case
and make a note of the eight-digit number.
Program the number into the system in
accordance with the following procedure:
1. Firmly close the doors and the rear
gate.
2. Open the driver's door, sit on the driv-
200718
er's seat, and close the door.
3. Perform the following steps within 45
seconds.
200719
1) Open and close the driver's door
once.
2
1) ON
2) LOCK
2) Insert the key into the ignition switch,
then turn it from the "LOCK" position to
the "ON" position 10 times within 15
seconds.
NOTE
When you complete step 2), an elec-
tronic tone will sound once.
If you do not perform steps 1) and 2)
within 45 seconds, an error will occur.
An electronic tone will not sound. In
this event, perform the whole proce-
dure again beginning with part 1.
200813
4. Open and close the door once within
15 seconds.
1
200814