Playing Recorded Clips - JVC GY-HM660U/GY-HM660E Basic Instructions

Playing Recorded Clips

Use the operation buttons on the side control panel
of the camera recorder to play back.
MENU/THUMB
AE LEVEL
A
B
C
CANCEL
.
A IW Button
Plays back/pauses the clip pointed by the
0
cursor.
You can press the cross-shaped button (HI)
0
to perform frame-by-frame forward playback
during pause mode.
B S/T Button
Skips in the reverse or forward direction.
O/N Button
During Playback:
Fast forwards in the reverse or forward
direction.
While paused:
Frame-by-frame playback in the reverse or
forward direction.
C o Button
Stops playback.
1 In the thumbnail screen, move the cursor to
the clip to be played back.
Move the cursor to the clip to be played back
using the cross-shaped button (JKH I).
2 Press the playback/pause button.
Playback of the selected clip starts.
Audio Output during Playback
You can confirm the playback sound from the
0
monitor speaker, or the headphone connected
to the [x] terminal. When a headphone is
connected to the [x] terminal, sound cannot be
output from the monitor speaker.
Adjust the volume of the monitor speaker and
0
headphone using the [MONITOR +/-] volume
adjustment button on the LCD monitor section
of the camera recorder.
22
Time Code Playback
Time code or user's bit recorded on an SD card can
be displayed on the LCD monitor and viewfinder.
Memo :
The time code is also superimposed on the
0
video signal output from the [HD/SD SDI] output
terminal.
User's bit output from the [HD/SD SDI] output
0
terminal is used as a flag to determine valid
video signals. Therefore, accurate values will
not be output.
If a section without time code is played back, the
0
time code will stop. However, playback will
continue.
Displaying Information during Shooting
During playback, pressing the [DISPLAY] button
shows the display screen.
Pressing the [AE LOCK/4] button switches the
display information during shooting between no
display, camera information display, and GPS
display.