Table of Contents
Advertisement
Basic Shooting
Procedures
Preparations
2
4
POWER
3
ON
OFF
(CHG)
MODE
.
1 Supply battery or AC adapter power to the
camera recorder.
2 Insert an SD card.
3 Turn on the power of the camera recorder.
Hold down the lock button (blue) at the center of
the [POWER ON/OFF(CHG)] switch to set to
"ON". The camera recorder starts up in Camera
mode and is ready for recording.
4 Adjust the angle of the LCD monitor and
viewfinder.
5 Configure [System], [Format], [Resolution]
and [Frame & Bit Rate] in [Main Menu] B
[System] B [Record Set] B [Record
Format].
You can select the definition of the recorded
0
videos (HD, SD or Web a), file format for
recording/playback, and the video recording
format on this camera recorder.
Press the [MENU/THUMB] button on the
0
LCD monitor to display the menu screen on
the LCD monitor and viewfinder.
The following setting values are the factory
0
defaults.
[System]: HD
[Format]: QuickTime(MPEG2)
[Resolution]: 1920x1080
[Frame & Bit Rate]: 60i(HQ) (U model) or
50i(HQ) (E model)
20
Shooting
1 Configure the video and audio input
settings.
You have to configure video settings such as
brightness adjustment (iris, gain, shutter) and
white balance adjustment in order to start
shooting. You also have to adjust the audio
input settings and audio recording level for
audio recording.
Adjusting the Brightness
4
0
Adjusting the White Balance
0
Adjusting Audio Input Settings and
0
Recording Level
2 Press the [REC] button to start recording to
the SD card.
This camera recorder has three [REC] buttons.
Any of the [REC] buttons can be used to start/
1
stop recording by default.
The tally lamp lights up in red during recording.
Zoom Operation
0
Adjusting the Focus
0
Memo :
If both the slots are loaded with recordable cards
0
in the factory default, pressing the [REC] button
starts recording only to the media in the selected
slot.
When [Main Menu] B [System] B [Record Set]
B [Slot Mode] is set to "Dual", recording can be
performed simultaneously to the cards in both
the slots.
The tally lamp can be turned off in [System] B
0
[Tally Lamp].
3 Check the most recently captured images.
Press the [C.REVIEW/7] button on the lens
0
to activate the Clip Review function. The
most recently captured images are played
back on the LCD monitor and viewfinder
screen.
After playback, the camera recorder returns
0
to standby mode (STBY).
Memo :
[Clip Review] is assigned to [C.REVIEW/7]
0
button in factory default.
[Clip Review] can also be assigned to other user
0
buttons.
Advertisement
Table of Contents
