Panasonic WV-SFN480PJ Operating Instructions Manual page 87

It is possible to fix the port number of the router used for H.264 image transmission via the Internet by
setting "Unicast port (MANUAL)" (®page 144). Refer to the operating instructions of the router in use.
•
Multicast: Unlimited number of users can access a single camera concurrently. Complete the entry field
of "Multicast address", "Multicast port" and "Multicast TTL/HOPLimit" when transmitting H.264 images with
multicast. Refer to page 7 for further information about the maximum concurrent access number.
•
Default: Unicast port (AUTO)
[Unicast port1(Image)]
Enter the unicast port number (used to transmit images from the camera).
When "Quad stream" is selected for "Image capture mode", a unicast port number can be selected for each
image (Ch1 to Ch4).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default:
–
H.264(1): 32004
–
H.264(2): 32014
[Unicast port2(Audio)]
Enter the unicast port number (used to transmit audio from the camera).
When "Quad stream" is selected for "Image capture mode", a unicast port number for audio can only be selected
for Ch1.
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default:
–
H.264(1): 33004
–
H.264(2): 33014
[Multicast address]
Enter the multicast IP address. Images and audio will be transmitted to the designated IP address.
When "Quad stream" is selected for "Image capture mode", a multicast address can be selected for each image
(Ch1 to Ch4).
•
Available IPv4 address: 224.0.0.0 - 239.255.255.255
•
Available IPv6 address: Multicast address starting with "FF"
•
Default:
–
H.264(1): 239.192.0.20
–
H.264(2): 239.192.0.21
Note
•
Enter a multicast IP address after checking available multicast address.
[Multicast port]
*2
Enter the multicast port number (used to transmit images from the camera).
When "Quad stream" is selected for "Image capture mode", a multicast port number can be selected for each
image (Ch1 to Ch4).
•
Available port number: 1024 - 50000 (Only even numbers are available.)
•
Default: 37004
Note
•
When audio is transmitted from the unit, the port number to be used will be the multicast port number
plus "1000".
[Multicast TTL/HOPLimit]
Enter a value for "Multicast TTL/HOPLimit".
•
Available value: 1-254
•
Default: 16
11 Configure the settings relating to images and audio [Image/Audio]
*1
*1
*2
*2
Operating Instructions 87