Panasonic WV-SFN480PJ Operating Instructions Manual page 142

14 Configure the settings relating to the authentication [User mng.]
Note
•
When "Quad stream" is selected for "Image capture mode", system settings are not available.
Priority stream
[Activation]
Select "On" or "Off" to determine whether or not to use the priority stream.
•
Default: Off
Note
•
When "On" is selected for "Activation" of "Priority stream", number of users who can access the camera
may be limited.
[Destination IP address(1)]
Enter the first destination IP address.
[Destination IP address(2)]
Enter the second destination IP address.
[Stream type]
Select "JPEG(1)", "JPEG(2)", "H.264(1)", or "H.264(2)".
•
JPEG(1): JPEG(1) images will be used for the priority stream.
•
JPEG(2): JPEG(2) images will be used for the priority stream.
•
H.264(1): H.264(1) images will be used for the priority stream.
•
H.264(2): H.264(2) images will be used for the priority stream.
•
Default: JPEG(1)
Note
•
When "Best effort" is selected for "Transmission priority" of "H.264", depending on the connection
condition of other users, the bit rate will vary between the maximum and minimum rates while images
are being transmitted.
•
When "On(NTSC)" or "On(PAL)" is selected for "Monitor out", "JPEG(1)" and "JPEG(2)" cannot be
selected.
[Refresh interval*]
Select the refresh interval from the following.
This setting is validated only when "JPEG(1)" or "JPEG(2)" is selected for "Stream type".
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps*/ 10fps*/ 12fps*/ 15fps*/ 30fps*
•
Default: 1fps
142 Operating Instructions