6. To install a 3.5-inch storage drive into the conversion bracket, do the following:
a. Flex both sides of the bracket and align pins
holes in the new 3.5-inch storage drive.
b. Install the new 3.5-inch storage drive into the bracket. Do not touch the circuit board
Figure 62. Installing the new 3.5-inch storage drive into the bracket
7. Ensure that the connectors on the storage drives are on the upper side. Then, slide the new 3.5-inch
storage drive with the conversion bracket into the storage drive bay until the drive snaps into position.
Figure 63. Installing the new 3.5-inch storage drive with bracket into the storage drive bay
8. Connect the signal cable and the power cable to the new storage drive.
1
,
2
,
3
, and
4
on the bracket with the corresponding
.
Chapter 7
Hardware removal and installation
5
on the drive.
91