Table of Contents
Advertisement
Power level settings
9 power level settings are available. The table gives the percentage of maximum
power for each setting with the time limit for operation at that power.
Power level
% of power
Time limit (mins)
Power boost function
Power boost is activated by turning the control clockwise from level 9.
The power boost will run for a maximum of 10 minutes before reverting to level 9. It
may be boosted again, providing the system internal temperatures are satisfactory.
On the SLI3 and SLI3W, power boosting raises the coil from 2.4kW to 3kW.
On the SLI21 and SLI42, if a rear coil (2kW) is power boosted, it's power increases to
3kW and the front coil will be shut down. If a front coil (1kW) is power boosted, it's
power increases to 1.8kW and the rear coil is limited to 1.2kW.
The SLI42 has independent left and right side generators; one coil on the left side and
one coil on the right side can be power boosted at the same time.
Automatic heat-up control (AHC)
When activated, the AHC will give maximum power (level 9) to a coil for a preset time
before reducing to a lower power level set by the control.
To activate, the control is turned anticlockwise from the 'Off' position for 2 seconds
whilst the 'A' symbol illuminates: within the next 10 seconds the control is turned
clockwise to set the final required power (1-8). The display then alternates between
the 'A' symbol and the set power level. The hob runs at maximum power for the time
shown in the table, before reducing power to the set power level.
Power level setting
Preset time (secs)
Control lock function
This function prevents unwanted operation of the hob. When the control lock is active,
the 'L' symbol is displayed. It is activated and de-activated by turning front and rear
control knobs anticlockwise to the control lock position, and holding for approximately
6 seconds.
This has to be performed separately for the left side and right side of the SLI42.
Pan detection function
This prevents the coils being turned on without a pan being present, and also turns off
the coil as soon as a pan is removed. If the pan is of the wrong material for induction
equipment, the 'no pan present' symbol is displayed.
Always use the control to switch off the hob after use.
IS 564 ECN 3766
1
2
3
3%
6%
11%
360
360
300
1
2
48
144
Page 9 of 13
4
5
6
15% 19% 31% 45% 64% 100%
300
240
90
3
4
5
230
312
408
7
8
9
90
90
90
6
7
120
168
216
8
Advertisement
Table of Contents
