Pontiac 1993 Grand Am Owner's Manual page 117

...
Comfort Controls & Audio Systems
CD Player Anti-Theft Feature
Delco LOC
I I @
is an anti-theft feature
for the compact disc player. It can be
used or ignored. If ignored, the system
plays normally. If it is used, your player
won't be usable if it is ever stolen,
because it will go to
LOC
mode any
time battery power is removed. It will
also go to LOC mode any time power
from the battery is turned off by the
Battery Rundown Protection feature (see
the Index under Battery Rundown
Protection). Until an unLOC code is
entered, it will not turn on.
The instructions below tell you how to
enter a secret code into the system. If
your vehicle loses battery power for any
reason, you must unlock the system with
the secret code before your audio system
will turn on.
To Set the Anti-Theft System:
1
.
Write down any six-digit number and
keep it in a safe place. This is your
secret code.
2. Turn the ignition to the Accessory or
Run position.
3. Press the PWR button to turn the
radio off.
1 1 6
4. Press station preset buttons 1 and 4
at the same time and hold until
"---"
appears on the display.
NOTE: You now have only 15 seconds
between each of the following steps.
5. Press SET, and 000 will appear on
the display.
6. Press the SEEK, button until the
first digit of your code appears.
7 . Rotate the lower knob right or left
until the second and third digits of
your code appear.
8. Press the lower knob (000 will
appear again on the display).
9. Press the SEEK, button until the
fourth digit of your code appears.
1 0. Rotate the lower knob right or left
until the fifth and sixth digits of
your code appear.
1 1
.
Press the lower knob
(rEP
will
appear for five seconds, then 000).
12. Repeat steps 6-11. This time SEC
will appear, indicating that Delco
LOC
I I @
is set, and your audio
system is secure.
To Disable the Anti-Theft System:
Enter your secret code by following
these steps (you will have only 15
seconds between each step).
1
.
Turn the ignition to the Accessory or
Run position, and turn the radio off.
2. Press station preset buttons 1 and 4 at
the same time. SEC will appear on
the display, indicating the audio
system is secure.
3.
Press SET, and 000 will appear on
the display.
4. Press the SEEK, button until the
first digit of your code appears.
5. Rotate the lower knob right or left
until the second and third digits of
your code appear.