30.1 General Installation Instructions - Siemens HN678GE.6B User Manual And Installation Instructions

Table of Contents

Advertisement

Recommended settings for microwave cooking
Food
Egg wash
Sponge
Meat loaf
Recommended settings for cooking in combination with the microwave mode
Food
Potato gratin
Cakes
Cakes
Chicken
1
Turn the dish 2/3 of the way through the cooking time.
30  Installation instructions
Observe this information when installing the appliance.
 30.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡ The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35 mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡ Ventilation slots and intake openings must
not be covered.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡ Do not use the door handle for the trans-
port or installation.
Accessories/cook-
ware
Uncovered cookware 2
Uncovered cookware 2
Uncovered cookware 2
Accessory/cook-
Shelf posi-
ware
tion
Uncovered cook-
2
ware
Uncovered cook-
2
ware
Uncovered cook-
2
ware
Wire rack
2
Shelf posi-
Heating func-
tion
tion
→ Page 11
Heating
Temperat-
function
ure in °C
→ Page 11
170–190
180–200
180–200
200–220
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
95 °C, and adjacent unit fronts up to
70 °C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ The mains socket for the appliance must
either be located in the hatched area
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket ⁠ .
Installation instructions en
Microwave
Cooking time in
power setting
mins
in W
1. 360
1. 20
2. 180
2. 20–25
600
7–9
600
22–27
Microwave
Cooking time
power setting
in mins
in W
360
25–30
180
18–23
180
18–23
360
25–35
1
or
49

Advertisement

Table of Contents
loading

Table of Contents