Boost; Recycle; Key Lock Setting - SmartVent positive+ User Manual

Modes

Boost

BOOST enables you to immediately override fan speed settings and boost fan speed to maximum.
- On the Home Screen, press SELECT
- In BOOST mode, the time segments will become a count down to the end of the BOOST mode.
- A quick tap of SELECT

Recycle

RECYCLE is designed for environments where extremes of temperature are common. When your system is in
VENTILATION mode and the roof cavity temperature exceeds the maximum roof cavity temperature (30ºC) setting,
or goes below the minimum roof cavity temperature (5ºC) setting, your SmartVent system will limit the amount of
air entering your home.
If HEAT TRANSFER is installed, the RECYCLE
mode recycling indoor air to help reduce condensation build-up. In RECYCLE mode the fan will operate at the
Recycle speed you set in the Recycle setting (default = OFF). Recycle temperature settings (004 and 005) can be
adjusted in the Advanced Setting Menu on page 13.
If a HEAT TRANSFER kit is not installed, it is recommended that Recycle speed is set to OFF.
- On the Home Screen, press SETTINGS
follow the guide below to complete.
RECYCLE mode may need to be activated. See Installation Instructions for details.

Key Lock Setting

When Key Lock is ON, system settings cannot be changed
- Press UP and DOWN
the system is locked.
- Press UP and DOWN
that the system is unlocked.
8
for 3 seconds and system's fan will boost to maximum speed.
on the Home Screen will exit BOOST mode.
3 seconds
icon will be displayed to indicate that your system is in RECYCLE
and then UP
Go to
FAN SPEED
setting
together for 3 seconds, until the KEY LOCK
together for 3 seconds, until the KEY LOCK
Tap to Exit
, or DOWN , to toggle to RECYCLE mode and
Select
FAN SPEED
value
icon is displayed, to confirm that
icon is not displayed, to confirm
Save all
settings
Go to
Home
Screen