Modes; Auto Operation And Temperature Setting - SmartVent positive+ User Manual

Modes

Auto Operation and Temperature (TEMP) Setting
Your SmartVent Positive+ system can choose where to draw air from and at what speed depending on the Dew
Point, and then the indoor and outdoor air temperatures, when in AUTO. If the system is in either BOOST or
RECYCLE modes, the fan will, instead, operate at the speeds set for those particular modes.
You select the SET temperature you want it to be in the home (ie. 22°C (default)) and the system will work on the
best air source to achieve your SET temperature
For example, if you set your system to 20°C while the current house temperature is 18.3°C, the control system
measures the incoming air temperature and alters the fan speed to suit. If the incoming air temperature is
20°C or higher, the fan will operate at a high speed to use the free heat to try and increase the overall house
temperature. If lower than 20°C, the fan speed would decrease to reduce the cooling effect
- On the Home Screen, press SETTINGS
- Press SELECT to enter VENTILATION mode then UP
follow the guide below to complete the setting of the SET temperature.
- Alternately, if already in ON and on the Home Screen, press SELECT
and follow the same guide below to adjust the temperature setting.
1) Your system is not a heating or cooling device. This parameter is designed to reduce nuisance over-heating or over-cooling of your home.
2) Additional features are available when low temperatures are present. See HEAT TRANSFER, TEMPERING HEATER and RECYCLE modes.
6
1) .
and then UP
Confirm
AUTO
operation
Go to
TEMP
value
, or DOWN , to toggle to VENTILATION mode
, or DOWN , to toggle to AUTO operation and
to toggle directly to AUTO operation
Select
TEMP
value
2)
.
Save all
settings
Go to
Home
Screen