Advanced Setting Menu - SmartVent positive+ User Manual

Advanced Settings

Advanced Setting Menu

SETTING DESCRIPTION
000 Touch Screen Controller - Firmware Version
001 Ceiling Controller - Hardware Version
002 Ceiling Controller - Firmware Version
003 Ceiling Controller - Macro Version
004 Recycle Temperature - Maximum
005 Recycle Temperature - Minimum
006 Temperature Set - Threshold
007 Temperature Set - Differential
008 Heat Transfer Speed - High
009 Heat Transfer Speed - Medium
010 Dew Point - High
011 Dew Point - Control Level
012 Dew Point - Start
013 Filter Used Percentage
014 Reserved
015 Temperature - Room
016 Screen Brightness - Maximum
017 Screen Brightness - Minimum
018 Boost Time
019 Filter Reset
1. If RECYCLE is enabled and the roof cavity sensor reading goes above the maximum recyle temperature setting or goes below the minimum recycle
temperature setting, then recycle mode will activate.
2. If your roof cavity or room temperature readings are inaccurate, use these settings to calibrate them.
3. To reset the filter change 019 setting value to 10 and press SELECT
RANGE
N/A
N/A
N/A
N/A
20°C - 50°C
0°C - 20°C
0°C - 5°C
0°C - 20°C
0°C - 15°C
0°C - 15°C
0°C - 15°C
0°C - 5°C
-5°C - 5°C
0 – 100%
N/A
-5°C - 5°C
0-100%
0-100%
0 min – 60 min
0 - 100
.
DEFAULT NOTE
N/A
N/A
N/A
N/A
30°C 1
5°C 1
1°C
5°C
5°C
2°C
5°C
1°C
0°C
0%
N/A
-0.5°C 2
80%
10%
20 min
0 3
15