Message Center - Mercury 2002 Villager Owner's Manual

Erasing HomeLink buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink buttons until the red
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink is now in the train (or
learning) mode and can be programmed at any time beginning with step
2 in the "Programming" section.
Reprogramming a single HomeLink button
To program a device to HomeLink using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release the
button.
2. The red indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink button, follow step 2 in the "Programming"
section.
For questions or comments, contact HomeLink at www.homelink.com
or 1–800–355–3515.
ELECTRONIC MESSAGE CENTER (IF EQUIPPED)
The electronic message center only works when the ignition is in the ON
position.
The message center allows you to:
• display the outside temperature.
• change your gauges from English
to metric units.
• monitor the instantaneous fuel
economy.
• monitor the average fuel
economy.
• see how many kilometers/miles you can drive before running out of
fuel.
Driver Controls
˚F ˚C
MILES/GAL
L/100 km
MILES km
OUTSIDE TEMP
INST ECONOMY
AVG ECONOMY
TO EMPTY
99