Air Bags - Mercury 2002 Villager Owner's Manual

Seating and Safety Restraints
and attaching hardware, should be inspected after a collision. Ford
recommends that all safety belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision was minor and a qualified
technician finds that the belts do not show damage and continue to
operate properly, they do not need to be replaced. Safety belt assemblies
not in use during a collision should also be inspected and replaced if
either damage or improper operation is noted. The front seat safety belt
assemblies must be replaced if the pretensioners have been activated.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Cleaning and maintaining the safety belts in the Cleaning
chapter.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
50 60
40 70
4 F
80 100 H
3 5
30 60 120 80 1/2 R
2
6
40 140 E C
20 90
FUEL TEMP
7
OFF
AUTO 0 0 0 0
1
0
AUTO
2
PUSH INTERIOR
CRUISE
ON OFF
Your vehicle is equipped with a crash sensing and diagnostic module
which records information about the air bag and sensor systems. In the
event of a collision this module may save information related to the
collision including information about the air bag system and impact
severity. This information will assist Ford Motor Company in servicing
the vehicle and in helping to better understand real world collisions and
further improve the safety of future vehicles.
136
VOL - PUSH ON
AM
CLK
FM
BASS TREB BAL FADE
TAPE
CD
AMS
SEEK
SIDE 1 - 2
SCAN EJ
TUNE
DISCS REW FF
CD CD COMP SHUFFLE
1 2 3 4 5 6
1 OFF
2
3
4 MAX
A/C
OFF REAR 1 2 3 4
A/C