Mercury 2002 Villager Owner's Manual page 98

Driver Controls
Operating the HomeLink Universal Transceiver
To operate, simply press and release
the appropriate HomeLink button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact Homelink at www.homelink.com.or
1–800–355–3515.
Rolling code programming
To train a garage door opener (or other rolling code equipped devices)
with the rolling code feature, follow these instructions after completing
the "Programming" in this section. (A second person may make the
following training procedures quicker & easier)
1. Locate the "learn" or "smart" button on the garage door motor
head unit. Exact location and color of the button may vary by product
brand. If there is difficulty locating the "learn" or "smart" button refer to
the device's owner manual or contact Homelink at 1–800–355–3515 or
on the Internet at www.homelink.com.
2. Press and release the "learn" or "smart" button on the garage door
motor head unit.
Note: Following step 2, there are 30 seconds in which to initiate step 3.
3. Press and release the
programmed HomeLink button.
Press and release the HomeLink
button a second time to complete
the training process. (Some garage
door openers may require this
procedure to be done a third time
to complete the training.)
The rolling code equipped device should now recognize the Homelink
signal and activate when the Homelink button is pressed. The remaining
two buttons may now be programmed if this has not previously been
done. Refer to the "Programming" in this section.
98