Mercury 2002 Villager Owner's Manual page 65

Climate Controls
If unusual conditions exist (i.e.-window fogging, etc.), the manual
override controls allow you to select airflow locations and the fan control
allows you to adjust fan speed as necessary.
Temperature selection
The display window indicates the
F
˚
selected temperature, function
AUTO
(AUTO or one of the override
controls) and manual control of fan
speed ( ) if automatic fan speed is not desired.
To control the temperature, select
any temperature between 15°C
OFF
(60°F) and 32°C (90°F) by pressing
the temperature controls. However,
individual temperature settings
between 15°C (60°F) and 18°C
OFF REAR 1
TEMP
A/C
(65°F) cannot be selected. The 15°C
AUTOMATIC
(60°F) and 18°C (65°F)
temperatures are the lowest settings
available.
For continuous maximum cooling, push the temperature control until
15°C (60°F) is shown in the display window. The EATC will continue
maximum cooling (disregarding the displayed temperature) until a
warmer temperature is selected by pressing the temperature controls.
For continuous maximum heating, push the temperature controls until
32°C (90°F) is shown in the display window. The EATC will continue
maximum heating (disregarding the displayed temperature) until a
cooler temperature is selected by pressing the temperature control.
Fan speed ( )
When AUTOMATIC is pressed, fan
speed is adjusted automatically for
HI
A/C
existing conditions. You can override
fan speed at any time. To control
MAX
fan speed manually, use the
thumbwheel to cancel automatic fan
1 2 3 4
speed operation. Rotate the
LO
thumbwheel or press the steering
wheel controls (if equipped) up for
higher fan speed or down for lower
fan speed.
65