Table of Contents
Advertisement
High beam flasher bulb
Press ends of housing cover 1 tab to-
gether and remove cover.
Press connector 2 downward.
Remove connector 2 with the bulb.
Insert the new bulb so that the base lo-
cates in the recess on the holder.
From below, press connector 2 with
bulb upward onto the reflector.
Align housing cover 1 and click into
place.
Front turn signal bulb
Turn bulb socket 4 counterclockwise
and pull out.
Gently push bulb into bulb socket 4,
turn counterclockwise and remove.
Insert new bulb in bulb socket 4, push
in and twist clockwise.
Reinsert bulb socket 4 in lamp and
twist clockwise.
Parking and standing lamp bulb
Press ends of housing cover 1 tab to-
gether and remove cover.
Pull out the bulb socket 3 with the
bulb.
Pull the bulb out of the bulb socket 3.
Insert a new bulb in the socket 3.
Reinstall the bulb socket 3.
Align housing cover 1 and click into
place.
Side marker lamp bulb
Carefully slide lamp towards rear.
Practical hints
Replacing bulbs
Remove front end first.
Twist bulb socket counterclockwise
and pull out.
Pull bulb out of the bulb socket.
Insert new bulb in socket.
Reinstall bulb socket, push in and twist
clockwise.
To reinstall lamp, set rear end in
bumper and let front end snap into
place.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a
front lamp, do the following first:
Turn the exterior lamp switch to M
( page 52).
Open the trunk ( page 101).
377
Advertisement
Table of Contents
