Front Panel(S) Installation Only (With Rear Hard Top Removed); Rear Hard Top Removal - Jeep 2009 Wrangler Owner's Manual

Hide thumbs Also See for 2009 Wrangler:

Table of Contents

118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Front Panel(s) Installation Only (With Rear Hard

Top Removed)

1. Turn the left and right panels over and move the

spacer block (located on the rear of the panel) upward 90

NOTE: The front panel(s) must be positioned properly

to ensure sealing. Set the panels on the windshield frame

so that there is no overhang. Also, make sure that the

panels are sitting flush with the body.

2. Install the right panel first, then the left panel.

3. Reinstall the panel(s) using the same steps for removal

in reverse order.

1. Remove both front panels. Refer to "Front Panel(s)

Removal" in this section.

2. Open both doors.

3. Remove the two Torx head screws that secure the

hard top at the B-pillar (near the top of the door) using a

#40 Torx head driver (Four–Door Only).

Chapters

Table of Contents