Rolling Code Programming - Hyundai 2009 Elantra Owner's Manual

Features of your vehicle
✽ ✽ NOTICE
For non rolling code garage door open-
ers, follow steps 2 - 3.
For rolling code garage door openers,
follow steps 2 - 6.
For Canadian Programming, please fol-
low the Canadian Programming section.
For help with determining whether your
garage is non-rolling code or rolling
code, please refer to the garage door
openers owner's manual or contact
HomeLink customer service at 1-800-
355-3515.
4 32
Flashing
Transmitter
2. Press and hold the button on the
HomeLink system you wish to train
and the button on the transmitter while
the transmitter is approximately 1 to 3
inches away from the mirror. Do not
release the buttons until step 3 has
been completed.
3. The HomeLink indicator light will flash,
first slowly and then rapidly. When the
indicator light flashes rapidly, both but-
tons may be released. (The rapid flash-
ing light indicates successful program-
ming of the new frequency signal.)
✽ ✽ NOTICE
Some gate operators and garage door
openers may require you to replace step
#3 with the "cycling" procedure noted in
the "Canadian Programming" section
of this document.

Rolling code programming

To train a garage door opener (or other
rolling code equipped devices) with the
rolling code feature, follow these instruc-
tions after completing the "Programming"
portion of this text. (A second person
may make the following training proce-
dures quicker & easier.)
4. Locate the "learn" or "smart" button on
the device's motor head unit. Exact
location and color of the button may
vary by product brand. If there is diffi-
culty locating the "learn" or "smart" but-
OHD046307N
ton, reference the device's owner's
manual or contact HomeLink at 1-800-
355-3515 or on the internet at
www.homelink.com.
5. Press and release the "learn" or
"smart" button on the device's motor
head unit. You have 30 seconds to
complete step number 6.
6. Return to the vehicle and firmly press
and release
HomeLink button up to three times.
The rolling code equipped device
should now recognize the HomeLink
signal and
HomeLink button is pressed. The
remaining two buttons may now be
programmed if this has not previously
been done.
"Programming" portion of this text.
the programmed
activate when the
Refer to the