Programming - Hyundai 2009 Elantra Owner's Manual

WARNING
• When

programming

HomeLink® Wireless
System, you may be operating a
garage door or gate operator.
Make sure that people and objects
are out of the way of the moving
door or gate to prevent potential
harm or damage.
• Do not use HomeLink with any
garage door opener that lacks the
safety stop and reverse feature
as required by federal safety
standards. (This includes any
garage door opener model manu-
factured before April 1, 1982.) A
garage door opener which cannot
detect an object, signaling the
door to stop and reverse, does
not meet current federal safety
standards. Using a garage door
opener without these features
increases risk of serious injury or
death. For more information, call
1-800-355-3515 or on the internet
at www.homelink.com.
Retain the original transmitter for future
programming procedures (i.e., new vehi-
cle purchase). It is also suggested that
the
upon the sale of the vehicle, the pro-
Control
grammed HomeLink buttons be erased
for security purposes (follow step 1 in the
"Programming" portion of this text).
Programming
Your vehicle may require the ignition
switch to be turned to the ACC position
for programming and/or operation of
HomeLink. It is also recommended that a
new battery be replaced in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker train-
ing and accurate transmission of the
radio-frequency.
Follow these steps to train your
HomeLink mirror:
Features of your vehicle
Flashing
1. When programming the buttons for the
first time, press and hold the left and
,
center buttons (
ously until the indicator light begins to
flash after approximately 20 seconds.
(This procedure erases the factory-set
default codes. Do not perform this step
to program additional hand-held trans-
mitters.)
OHD046306N
) simultane-
4 31