Add Target; Edit Target - HDL Tile Series User Manual

3.4.1

Add Target

If the button supports two or more targets, then the user can add target. This part takes
"adding two more targets to the long press mode of Button 1" as an example.
1. Set the mode of Button 1 to "Short/long press" on the left of button configuration page.
2. Select Button 1, and click "Target Configuration" to open target configuration window.
3. Select "Long Press" in button status type (Mark ② of Figure 3-4).
4. The total target number will be 3 if 2 more targets is to be added as there's 1 target by
default. Thus, enter "from 1 to 3" in "Input target number", and click "Read" button.
5. Then there will be 3 targets in the target list below, click "Save".
3.4.2

Edit Target

Add targets according to
(Continued from the preceding part)
HDL Automation Co., Ltd.
http://www.hdlautomation.com
Figure 3-4 Button Target Configuration
Add Target, and then the targets can be configured.
Tile Series Button Panel (Buspro) User Manual
8