Related Manuals for HDL Buspro Wireless
Summary of Contents for HDL Buspro Wireless
- Page 1 M_Pairing_of _Buspro_Wireless_devices_(2019-11)_EN Buspro Wireless Pairing devices to the wireless network Description of procedure and settings v. 2019/11/7 © HDL Automation s.r.o. JU 1 z 6 Buspro Wireless: Pairing_of Buspro Wireless_devices...
- Page 2 2.1. Connecting the wireless gateway to the computer ............3 Ethernet setup ........................3 2.2. Network parameters setup ....................4 Search and load the Buspro Wireless IP gateway ............4 Setting up the wireless network address system ............. 4 Setting the transmission parameters of the wireless network ........4 2.3.
-
Page 3: Setup Procedure
M_Pairing_of _Buspro_Wireless_devices_(2019-11)_EN 1. General Buspro Wireless is part of the Buspro system, the devices of which communicate with each other via a cable bus. Wireless devices do not require a cable bus, but communicate wirelessly in a dedicated frequency band. This results in a difference in commissioning the system. - Page 4 Fig.2 Wireless gateway HDL-MCIP-RF02.10 and its connection to the PC Setting up the wireless network address system After loading the gateway, select the address system of the Buspro Wireless network. The address consists of two parts, Subnet ID and Device ID, see Fig. 2. Select the value of the Subnet ID parameter, the factory setting is usually 200, values from 1 to 255 can be used.
-
Page 5: Pairing Devices
If the device has a "programming button" such as a wireless relay, etc., this button is pressed three times in rapid succession, causing the device's light to flash rapidly at 2 Hz 5 z 6 Buspro Wireless: Pairing_of Buspro Wireless_devices... -
Page 6: Setting Devices
For details, see the manual Introduction to the HDL Wireless System, or in the case of newer types, this information is given in the catalog sheet of the device. The most common types of drivers are set as follows: •...