Table of Contents
Advertisement
Available languages
Available languages
Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Symptom
No sound is heard.
The disc sound is discontinuous.
The disc does not play.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the remote
control.
Resetting the unit
If "Troubleshooting"
(see above)
malfunctioning (failure to operate or display properly etc.),
press the reset switch on the back of the unit with
something having a sharp point.
If you reset the unit
Resetting causes the unit to restore its factory default settings and
results in all the settings made by the user being deleted.
Specifications
Amplifier section — CA-PCX270
Output Power
5 W per channel, min. RMS, driven into 3 Ω at 1 kHz with no
more than 10% total harmonic distortion.
Audio input sensitivity/Impedance (at 1 kHz)
AUX:
1 000 mV/47 kΩ
Speakers/Impedance: 3 Ω –
8
Tuner
FM tuning range:
87.90 MHz – 107.90 MHz
AM tuning range:
520 kHz – 1 710 kHz
CD player
CD Capacity:
1 CD
Dynamic range:
60 dB
Signal-to-noise ratio: 75 dB
Wow and flutter:
0.1 %
Cassette deck
Frequency response
Normal (type I): 50 Hz — 10 000 Hz
Wow and flutter:
0.2% (WRMS)
Connections are incorrect or loose.
The disc is scratched or dirty.
The disc is placed upside down.
Small tabs on the back of the cassette are removed.
The built-in microprocessor may malfunction
due to external electrical interference.
• The path between the remote control and
the remote sensor on the unit is blocked.
• The batteries are exhausted.
does not eliminate
Ω
Cause
Check all connections and make corrections.
(See pages 6 and 7.)
Clean or replace the disc. (See page 17.)
Place the disc with the label side up.
Cover the holes with adhesive tape.
Unplug the AC power cord after removing the
batteries from the unit, and then plug it back in.
• Remove the obstruction.
• Replace the batteries.
Design and specifications are
subject to change without notice.
General
Power requirements:
AC 120 V
DC 12 V ("R20(SUM-1)/D(13D)" batteries
(8))
External DC 12 V
optional CA-R120 car adapter)
Power consumption:
25 W (at operation)
3 W (on standby)
Dimensions (approx.): 267 mm x 298 mm x 254 mm (W/H/D)
(10
Mass (approx.):
3.5 kg (7.8 lbs)
Supplied accessories
See page 6.
Speaker section — SP-PCX270
T
ype:
2-way bass-reflex type
Speaker units:
Woofer:
Tweeter:
Power handling capacity: 5 W
3 Ω
Impedance:
Frequency range:
50 Hz — 18 000 Hz
Dimensions (approx.): 193 mm x 289 mm x 254 mm (W/H/D)
(7
Mass (approx.):
1.6 kg (3.6 lbs) each
– 18 –
Action
sharp point
, 60 Hz
(car battery via
9
/
in. x 11
3
/
in. x 10 in.)
16
4
3
12 cm (4
/
in.) cone x1
4
5 cm (2 in.) cone x1
5
7
/
in. x 11
/
in. x 10 in.)
8
16
Advertisement
Chapters
Table of Contents
