Table of Contents
Advertisement
０６／０７／２６ １８：１６：５１ ３１ＳＨＪ６２０ ０４１５
Malfunction Indicator Lamp, Readiness Codes
Malfunction Indicator Lamp
If this indicator comes on
while driving, it means one
of the engine's emissions control
systems may have a problem. Even
though you may feel no difference in
your vehicle's performance,
continued operation may cause
serious damage.
If the indicator comes on repeatedly,
even though it may turn off as you
continue driving, have your vehicle
checked by your dealer as soon as
possible.
If you keep driving with the
malf unction indicator lamp on, you can
damage your vehicle's emissions
controls and engine. Those repairs may
not be covered by your vehicle's
warranties.
410
The indicator may also come on with
the ''D'' indicator.
On Touring models
You will also see a ''CHECK
EMISSION SYSTEM'' message on
the multi-information display (see
page
88
).
Readiness Codes
Your vehicle has certain ''readiness
codes'' that are part of the on-board
diagnostics for the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.
If your vehicle's battery has been
disconnected or gone dead, these
codes are erased. It can take several
days of driving under various
conditions to set the codes again.
To check if they are set, turn the
ignition switch to the ON (II)
position without starting the engine.
The malfunction indicator lamp will
come on for 20 seconds. If it then
goes off, the readiness codes are set.
If it blinks 5 times, the readiness
codes are not set. If possible, do not
take your vehicle for a state
emissions test until the readiness
codes are set. Refer to
State
Emissions Testing
for more
information (see page
435
).
Advertisement
Chapters
Table of Contents
