Honda 2007 Odyssey Owner's Manual page 233

０６／０７／２６ １７：５２：３２ ３１ＳＨＪ６２０ ０２３２
To Play the AM/FM Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button, or AM/FM button. On
the FM band, ST will be displayed if
the station is broadcasting in stereo.
Stereo reproduction in AM is not
available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN,
preset buttons, and AUTO SELECT
TUNE Use the TUNE knob to
−
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
The SEEK function
SEEK −
searches up and down from the
current frequency to find a station
with a strong signal. To activate it
press the ＋ or − side of the bar,
then release it.
SCAN − The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
the a station with a strong signal. When
. it finds one, it will stop and play that
station for about 5 seconds.
Playing the AM/FM Radio
If you do nothing, the system will
then scan for the next strong station
and play it for 5 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
Each preset button can
Preset −
store one frequency on AM and two
frequencies on FM.
1. Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each preset
button.
2. Use the tune, seek, or scan
function to tune the radio to a
desired station.
3. Pick a preset button, and hold it
until you hear a beep.
4. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
CONTINUED
227