This manual is intended but for qualified technical staff and not for end
user. It is a task of the installer to inform afterwards user on the use of the
automatism and on possible dangers could come from it, as well as on the
need of a periodical maintenance.
The set up is to be carried on only by qualified staff having got required
technical and professional requirements.
The product is to be installed complying with rules in force about computer
-based closings.
The device has been realised expressly to automate wing gates. Any other
employ is to be considered improper and therefore forbidden.
Always use original components. The Company Leb doesn't take any
responsibilities for damages due to the use of non-original components.
Before proceeding with set up, make sure the gate frame is solid and fitted
for the employ of the device.
Before proceeding with set up, make sure that, during the gate move,
there are not friction points and that this one has no possibilities to come
off the hinges.
Before acting on the device, check the power supply voltage is
disconnected.
The equipment is not to be handled by children or inexpert.
The reduction gear is of irreversible type and therefore doesn't need an
electric lock. The use of an electric lock is anyway advisable on wings
having a length close to 2,5 m to ensure a more effective closing.
The mains power supply must be supplied to the device with an all-pole
switch. We recommend to use a 6A thermal breaker with a differential
protection having a 0.03A threshold.
In case of lack of electric voltage, start the unblocking device to manually
open or close the gate.
The maintenance of the device is to be executed but by qualified staff
authorized by the Manufacturer.
Check the condition of the gate hinges any six months and lubricate them
when necessary.
Warnings
7
ENGLISH