Power Button Function
During Suspend, if you push the switch once, the system goes
into suspend mode and if you push it more than 4 seconds, the system will
be turned off. During On/Off, the system will turn off once you push the
switch.
Restore on AC/Power Loss
The settings are power on, power off or last state. During power
on, after every AC power loss, the system will be turned on. During last
status, after every AC power losss, whatever the system status, it will be the
same when the AC power returns.
Resume On Ring/LAN
During Disabled, the system will ignore any incoming call from the
modem/LAN network card. During Enabled, the system will boot up if
there's an incoming call from the modem/LAN network card.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system. Then, power off the system. This
function will work the next time you power on.
Resume On PME#
During Disabled, the system will ignore any event on PME (Power
Management Event). During Enabled, the system wull boot up if there's an
event on PME. The default setting is Disabled.
®
3-15