Declaration Of Incorporation According To 2006/42/Ec (Machinery Directive) - GEM Q50 eSyStep Operating Instructions Manual

18 Declaration of Incorporation according to 2006/42/EC (Machinery Directive)

according to the EC Machinery Directive 2006/42/EC, Annex II, 1.B for partly
We,
declare that the following product
Make:
Serial number:
Project number:
Commercial name:
meets the following essential requirements of the Machinery Directive 2006/42/EC:
1.1.5, 1.2.1, 1.2.2, 1.2.3, 1.2.5, 1.3., 1.3.2, 1.3.4, 1.3.7, 1.3.8, 1.3.9, 1.5.3, 1.5.5, 1.5.14, 1.6.1, 1.6.3
We also declare that the specific technical documentation has been compiled in accordance with part B of Annex VII.
The manufacturer or his authorised representative undertake to transmit, in response to a reasoned request by the national au-
thorities, relevant information on the partly completed machinery. This transmission takes place:
Electronically
Authorised documentation officer
This does not affect the industrial property rights!
Important note! The partly completed machinery may be put into service only if it was determined, where appropriate, that the
machinery into which the partly completed machinery is to be installed meets the provisions of this Directive.
2021-08-09
Joachim Brien
Head of Technical Department
www.gemu-group.com
Declaration of Incorporation
completed machinery
GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Fritz-Müller-Straße 6-8
74653 Ingelfingen-Criesbach, Germany
GEMÜ pinch valve
From 1st October 2020
SQ_GEMÜ_Q50
GEMÜ Q50
GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Fritz-Müller-Straße 6-8
74653 Ingelfingen, Germany
18 Declaration of Incorporation according to 2006/42/EC (Machinery Directive)
49 / 52 GEMÜ Q50 eSyStep
Open / Close (Code AE, A5, A6)