Download Print this page

Scott TRIGGER User Manual page 6

Knee guard

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
LIMB PROTECTOR
TYPE A & B
1
Stands for the size of the protectors and is applicable to all joint
impact protectors. Type A refers to the standard dimensions of
protection for the average user. Type B has an additional wider
area of protection compared to type A.
LEVEL
The performance is based on the amount of impact transmission measured in kN (kilo Newton).
The EN 1621-1 (shoulder, elbow, knee, hip, leg) standard provides 2 Levels of protection: Level 1 and
2
Level 2. Level 1 protectors shall have an overall mean value below 35kN, each single strike shall not
exceed 35kN in the area I, and 50kN in the area II and III. Level 2 protectors shall have an overall
mean value below 20kN, each single strike shall not exceed 20kN in the area I, and 30kN in the
area II and III.
Level 2 protectors offer higher performance than Level 1 protectors.
Level 2 protectors offer the highest Level specified by the CE standard. Due to the extra Level of
protection Level 2 protectors may be heavier, thicker and less ergonomic than the Level 1 protectors.
It is up to the responsibility of the rider to choose the correct Level of protection according to their
needs, their experience, their performance and skills.
TEMPERATURE
3
T+ means the protection is tested and certified for temperatures up to +40 degrees Celsius.
T- means the protection is tested and certified for temperatures down to –10 degrees Celsius.
All SCOTT protections are certified with ambient and wet conditioning. Wet conditioning testing is
used to simulate the high humidity experienced during sports.
• VII. HOW TO ADJUST YOUR PROTECTOR
CHOOSING YOUR CORRECT SIZE 
It must be chosen in reference to the size indicated in the follow-
ing size chart or on the garment itself. SCOTT Sports SA shall not
accept any complaints arising from the use of an incorrectly fit-
ted protector.
TOP CIRCUMFERENCE, 10CM FROM KNEE CUP
BOTTOM/CALF CIRCUMFERENCE
PROTECTOR POSITION AND FIT 
The knee guards should not cause discomfort in your usual rid-
ing position. Be sure that the knee caps are correctly positioned
over your own knee caps. Do not over tighten the gripping straps
blood circulation could be affected.
ENGLISH - 6
Reference for Personal Protective
Equipment that is in compliance with the
EN 1621-1 :2012
European harmonized technical standard
used in the design and CE certification
c : Category and type of protection
Category: S: shoulder & forearm, E: elbow,
K: knee & upper tibia, H: hip, L: leg Type: A, B
d :   L evel of protection
e :  T+: High temperature impact test passed
f :  T-: Low temperature impact test passed
2
A
A
I
II
UNISIZE
cm
39-50 cm
32-43 cm
1
3
3
B
B
III
I
II
III

Advertisement

loading