Serial Port Jumper Configuration - NetBurner SB72EX User Manual

For Flow Control, the default setting is None. If you are using flow control, set this option appropriately.
Note: You must click the Submit New Settings button on the bottom of this page to save your settings
Remember, if you are only using one port, you can ignore the other port's section.

Serial Port Jumper Configuration

Click the Jumper Configuration link on this page to view Port 0 and Port 1 jumper configuration and
pinout information.
Note: To get back to the Serial section after viewing this page, click on the Return to Setup Page button
directly above the SB72EX diagram.
SB72EX User's Manual, 350030-001 Page 12
Downloaded from Elcodis.com electronic components distributor