Device Connection Settings (Udp Mode) - NetBurner SB72EX User Manual

Device Connection Settings (UDP mode)

Return to the Network section by clicking on the Network link directly above the Advanced Serial section.
Click on the Switch to UDP mode link,(directly under your SB72EX settings) to go to the UDP section.
You will see "System is set to UDP mode" after you click the Switch to UDP mode link
When you are finished with this section, click the appropriate button at the bottom. Submit New Settings
will save your settings, and Reset to Factory Defaults will restore the factory values. Enter your valid
destination IP address as a numeric address separated by periods. Remember, if you are only using one
port, you can ignore the other port's section.
SB72EX User's Manual, 350030-001 Page 9
Downloaded from Elcodis.com electronic components distributor