Using Homelink; Gate Operator And Canadian Programming - Chevrolet 2005 SSR Pickup Owner's Manual

8. Return to the vehicle. Firmly press and hold the
programmed HomeLink
then release. Repeat the press/hold/release
sequence a second time, and depending on the
brand of the garage door opener (or other rolling
code device), repeat this sequence a third time
to complete the programming.
®
HomeLink should now activate your rolling-code
equipped device.
To program the remaining two HomeLink
begin with Step 2 of "Programming HomeLink
You do not want to repeat Step 1, as this will erase
all previous programming.
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to "time out" or quit after several seconds
of transmission. This may not be long enough for
®
HomeLink to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured
to "time out" in the same manner.
®
button for two seconds,
®
buttons,
®
."
If you live in Canada, or you are having difficulty
programming a gate operator by using the
"Programming HomeLink
where you live), replace Step 3 under "Programming
®
HomeLink " with the following:
Continue to press and hold the HomeLink
while you press and release every two seconds (cycle)
your hand-held transmitter until the frequency signal
has been successfully accepted by HomeLink
The indicator light will flash slowly at first and then
rapidly. Proceed with Step 4 under "Programming
®
HomeLink " to complete.
®

Using HomeLink

Press and hold the appropriate HomeLink
for at least half of a second. The indicator light will
come on while the signal is being transmitted.
®
" procedures (regardless of
®
button
®
.
®
button
2-33