Chevrolet 2005 SSR Pickup Owner's Manual page 110

Windscreen
Rear View of Seatback
A. Windscreen
B. Bevelled Notch in Carpeted Seatback Bumper
C. Protective Cap on Carpeted Seatback Bumper
The vehicle may have a windscreen (A) installed
to the rear of each seat to lessen wind noise while
the convertible roof is retracted. The convertible roof
can be opened or closed with the windscreen installed.
2-52
The vehicle must have the correct seatback bumpers to
install the windscreen. The correct seatback bumpers
have a bevelled notch (B) above the seat's inboard
protective cap (C). The notch allows the bumper to fit
over the windscreen bracket which mounts to the
inboard mounting studs.
Install the windscreen by following these steps:
1. Before installing the windscreen, the convertible top
must be fully retracted and the seats moved forward.
2. Remove the windscreen from its protective bag.
3. Locate the carpeted seatback bumper behind
each seat.
4. Remove protective caps from the bumpers.
5. Loosen the four seatback bumper nuts from each
seat. It is not necessary to remove the bumpers
completely.
6. With the seatback bumpers loosened, slide the
windscreen mounting brackets behind the
seatback bumpers. The angled portion of the
mounting brackets should rest tightly into the
bevels of the seatback bumpers.
7. Tighten the bumper nuts and reinstall the protective
molding caps.
When not using the windscreen, store it in its
protective bag.