Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet 2005 SSR Pickup Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low to high beam,
push the lever toward the instrument panel. To return
to low-beam headlamps, pull the multifunction lever
toward you. Then release it.

Flash-to-Pass

This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
It works even if your headlamps are in the automatic
position.
To use it, pull the turn signal lever toward you, then
release it.
If your headlamps are in the automatic position or on
low beam, your high-beam headlamps will turn on.
They'll stay on as long as you hold the lever toward you.
3-8
When the high beams are
on, this indicator light on
the instrument panel
cluster will also be on.
The high-beam indicator on the instrument panel cluster
will come on. Release the lever to return to normal
operation.

Windshield Wipers

N
(Windshield Wipers): To use the windshield
wipers, turn the band with the wiper symbol on it.
8
(Mist): For a single wiping cycle, turn the band to
mist. Hold it there until the wipers start. Then let go.
The wipers will stop after one wipe. If you want
more wipes, hold the band on mist longer.
Delayed Wipers: You can set the wiper speed for a long
or short delay between wipes. This can be very useful in
light rain or snow. Turn the band to one of the dashed
marks on the lever to choose the delay time. The closer
to the top of the lever, the shorter the delay.
6
(Low Speed): For steady wiping at low speed,
turn the band away from you to the first solid band past
the delay settings.
1
(High Speed): For high-speed wiping, turn the
band further, to the second solid band past the
delay settings.
9
(Off): Turn the band to this symbol to turn off your
windshield wipers.