How To Connect Power Line And Thermistor Cable - Sanden EcoPlus GAUS-300FQS Owner's Manual

How to connect power line and thermistor cable

Please note: Electrical installation should only be completed by an EcoPlus
approved electrician.
Remove the piping cover screw clamp fitting.

Connect the power supply line to the terminal block.

Hold the power supply line below the terminal block with the screw clamp fitting.

Connect the thermistor cable line to the terminal block.

Hold the thermistor cable with the code clip and conduit clip

Attach the piping cover back on the heat pump unit.

Figure 6: Connect power cables
25mm or less
Sanden Heat Pump – Owner's Manual
Page 13 of 20